A.changing the angle of the tilting plate
B.changing the speed of the pump
C.moving the slide block and rotor
D.moving the shaft trunnion block
您可能感興趣的試卷
你可能感興趣的試題
A.oil foaming in the compressor
B.higher than normal suction and discharge pressures with a higher box temperature
C.higher than normal discharge pressure with a normal box temperature
D.the compressor to run continuously
A.check hydraulic oil levels every hour
B.check the rams for overheating
C.check for excessive oil leakage from rams
D.drain water from telemotor cylinders each watch
A.prevent the gear box from leaking
B.prevent the oil from becoming inflammable
C.make sure it has not become contaminated
D.make sure the motor bearings are lubricated
A.slightly opened
B.throttled
C.fully opened
D.halfway opened
A.increase speed
B.increase the size of the cardent assembly
C.reduce wearing ring clearances
D.change the pump to a "close coupled" arrangement
最新試題
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
One cause of high head pressure occurring in a refrigeration system can be （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
Which of the listed pumps is NOT a positive displacement pump?（）
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.