A.the relief valve should open before the high pressure cutout
B.the relief valve should open and allow the excess refrigerant to flow to the receiver
C.the high pressure cutout switch should operate before the relief valve opens
D.you should close in on the suction valve
您可能感興趣的試卷
你可能感興趣的試題
A.cause of salt contamination
B.location of salt water contamination
C.chemical makeup of feed-water
D.level of alkalinity in condensate
A.restriction in refrigerant piping
B.air and non-condensable gases in the condenser
C.water in the refrigerant
D.flooding back of liquid refrigerant from the evaporator
A.A shortage of liquid refrigerant
B.Excessive frost on the evaporator
C.Excessive condenser cooling water
D.Insufficient condenser cooling water flow
A.eliminate hot air from the condenser
B.maintain steady pressure in a system
C.heat, or cool one fluid by means of another fluid
D.reduce the engine room temperature in tropical climates
A.Cross
B.Parallel
C.Counter
D.Circular
最新試題
The usual symptoms of cavitation in a centrifugal pump is （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
The major source of chemical contaminants in hydraulic fluid is （）.
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.
A salinity indicator is used to determine the （）.
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
Which of the following statements is correct concerning heat transfer?（）
The general purpose of a heat exchanger is to （）.