A.add fluid that is the same color as the fluid in the reservoir
B.add turbine oil because it is always a good substitute
C.add any oil that has the same viscosity as the hydraulic fluid
D.check the winch manufacturers instruction book
您可能感興趣的試卷
你可能感興趣的試題
A.changing the angle of the tilting plate
B.changing the speed of the pump
C.moving the slide block and rotor
D.moving the shaft trunnion block
A.oil foaming in the compressor
B.higher than normal suction and discharge pressures with a higher box temperature
C.higher than normal discharge pressure with a normal box temperature
D.the compressor to run continuously
A.check hydraulic oil levels every hour
B.check the rams for overheating
C.check for excessive oil leakage from rams
D.drain water from telemotor cylinders each watch
A.prevent the gear box from leaking
B.prevent the oil from becoming inflammable
C.make sure it has not become contaminated
D.make sure the motor bearings are lubricated
A.slightly opened
B.throttled
C.fully opened
D.halfway opened
最新試題
A pressure drop through the refrigerant liquid line may cause （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.
Low compressor head pressure in a refrigeration system can be caused by（）.
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?（）
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.