A.Liquids with different viscosities will always have the same specific gravity
B.Liquids with different viscosities will never have the same specific gravity
C.Viscosity and specific gravity are directly proportional
D.Viscosity and specific gravity are not related in that one does not define or limit the other
您可能感興趣的試卷
你可能感興趣的試題
A.stored at temperatures below 60 degrees Fahrenheit
B.charged into a system having copper fittings
C.allowed to mix with compressor oil
D.exposed to an open flame or hot surface
A.acid formation
B.sludge formation
C.ice in the expansion valve
D.All of the above
A.superheated outside the system
B.in contact with an open flame
C.heated to the boiling point
D.All of the above
A.Variable volumes can be obtained with gear pumps only by variation of the pump drive speed
B.A radial piston pump houses sliding pistons in a stationary cylinder block through which passes a rotating pintle or ported shaft
C.The amount of fluid displaced per revolution of an axial piston rotary pump is dependent on the angle formed between the cylinder block and valve plate
D.All of the above
A.transmit the rudder angle to the bridge indicator
B.prevent the control linkage from striking the stops when hard over
C.automatically purge all entrained air from the system
D.send hydraulic signals to the receiving unit
最新試題
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().
Which of the listed pumps is NOT a positive displacement pump?()
The general purpose of a heat exchanger is to ().
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should ().
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
A salinity indicator is used to determine the ().
Thermostatic expansion valves can be adjusted for ().
An excessive charge of refrigerant in an air-cooled refrigeration system can cause ().
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?()
When the steering gear is in operation, you should ().