A.increase the amount of cooling water to the condenser
B.decrease the amount of cooling water to the condenser
C.add more refrigerant to the system
D.remove some refrigerant from the system
您可能感興趣的試卷
你可能感興趣的試題
A.Heat is given off from a high temperature region known as a heat sink
B.Heat transfer rate is affected most by the size of the heat sink involved
C.Heat transfer rate is affected most by the temperature difference between the heat source and the heat sink
D.Heat transfer by radiation will occur only by mass motion of a fluid substance
A.Maritime Safety Administration
B.Master of the vessel
C.Chief Engineer
D.Chief Mate
A.size of the heat sink
B.temperature difference between the regions
C.size of the heat source
D.total heat of the system
A.the four-way control valve failing to shift
B.the bleeder valve sticking in the open position
C.cold hydraulic fluid
D.a clogged air vent falter on the oil reservoir
A.add fluid that is the same color as the fluid in the reservoir
B.add turbine oil because it is always a good substitute
C.add any oil that has the same viscosity as the hydraulic fluid
D.check the winch manufacturers instruction book
最新試題
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is （）.
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
Who is responsible for ensuring that someone is assigned to close the watertight doors in an emergency?（）
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
The major source of chemical contaminants in hydraulic fluid is （）.