A.stored at temperatures below 60 degrees Fahrenheit
B.charged into a system having copper fittings
C.allowed to mix with compressor oil
D.exposed to an open flame or hot surface
您可能感興趣的試卷
你可能感興趣的試題
A.acid formation
B.sludge formation
C.ice in the expansion valve
D.All of the above
A.superheated outside the system
B.in contact with an open flame
C.heated to the boiling point
D.All of the above
A.Variable volumes can be obtained with gear pumps only by variation of the pump drive speed
B.A radial piston pump houses sliding pistons in a stationary cylinder block through which passes a rotating pintle or ported shaft
C.The amount of fluid displaced per revolution of an axial piston rotary pump is dependent on the angle formed between the cylinder block and valve plate
D.All of the above
A.transmit the rudder angle to the bridge indicator
B.prevent the control linkage from striking the stops when hard over
C.automatically purge all entrained air from the system
D.send hydraulic signals to the receiving unit
A.horizontally mounted
B.never fitted with intake filters
C.fitted with intercoolers
D.operated in an unloaded condition at all times
最新試題
Which of the listed pumps is NOT a positive displacement pump?()
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by ().
A salinity indicator is used to determine the ().
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
If the head pressure of a reciprocating refrigeration compressor is excessive, ().
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?()
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will ().
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by ().
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by ().