A.refrigerant must be bled off the sensing line before adjustments are made
B.all refrigerant must be pumped into the receiver before adjustments are made
C.time must be allowed for conditions to stabilize in the evaporator before further adjustments are made
D.all refrigerant must be routed through the dehydrator while changing the superheat setting
您可能感興趣的試卷
你可能感興趣的試題
A.motor controller overload would open
B.pump would eventually overheat
C.relief valve would continuously cycle open
D.motor would overheat
A.have a greater head capacity
B.operate with increased impeller efficiency
C.discharge through the suction side of the pump casing
D.require more power to run the shaft
A.hydraulic fluid contamination
B.excessive fluid friction
C.turbulent fluid flow
D.fluid pressure surges
A.yearly
B.quarterly
C.monthly
D.daily
A.evaporator pressure decrease
B.evaporator coil over-feed
C.evaporator capacity increase
D.expansion valve diaphragm rupture
最新試題
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
When the steering gear is in operation, you should （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of （）.
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.