A.Bluetooth
B.frequency hopping
C.microwave oven
D.802.11b client card
E.802.11b access point
您可能感興趣的試卷
你可能感興趣的試題
A.ISM 2.4 GHz
B.ISM 900 MHz
C.ISM 5 GHz
D.public safety 4.9 GHz
E.GSM 1.9 GHz
A.data/coverage
B.location with Monitor Mode access points
C.demand
D.high density
A.100 mW， 24 Mb/s
B.100 mW， 18 Mb/s
C.25 mW， 18 Mb/s
D.3.2 mW， 54 Mb/s
A.In a multifloor building， the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor， without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork
A.Active mode does not require the client to be specifically confgured
B.Passive mode can survey more than one access point at a time
C.Active mode yields signal-quality information such as packet retries and lost packets
D.Active mode requires more time to survey but yields more information results than passive mode does
最新試題
Which two methods can be used to prevent or reduce RFI from colocated directional antennas（）
Which statement regarding the site-survey process is correct？（）
What is the minimum recommended access point overlap for voice roaming？（）
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas？（）
Which can NOT be selected for supported services in Cisco WCS Planning Tool？（）
Which three device types are identified by Cisco Spectrum Expert Wi-Fi finding an Avg PulseDuration parameter？（）
What does a broad-spectrum interferer lower？（）
When planning for VoWLAN capacity during a site survey， how many simultaneous calls can beestimated per 5 GHz channel？（）
After the site installation is complete， you should verify the mobility of the VoWLAN device whilewalking the site on an active phone call. Which Cisco WLC or Cisco WCS command is mostbeneficial in determining roaming efficiency？（）
In an outdoor bridge link， what is calculated by using this formula： transmitter power + antennagain - insertion OR cable loss（）？