A.data/coverage
B.location with Monitor Mode access points
C.demand
D.high density
您可能感興趣的試卷
你可能感興趣的試題
A.100 mW， 24 Mb/s
B.100 mW， 18 Mb/s
C.25 mW， 18 Mb/s
D.3.2 mW， 54 Mb/s
A.In a multifloor building， the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor， without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork
A.Active mode does not require the client to be specifically confgured
B.Passive mode can survey more than one access point at a time
C.Active mode yields signal-quality information such as packet retries and lost packets
D.Active mode requires more time to survey but yields more information results than passive mode does
A.20 percent cell overlap
B.four access points detecting a client at -76 dBm or better
C.10 percent cell overlap
D.three access points detecting a client at -75 dBm or better
A.at 30mW
B.matched to the antenna gain
C.differing by at least 20 dBi
D.matched to each other
最新試題
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS？（）
When conducting a wireless voice site survey， which two sizing considerations exist for thecoverage cell？（）
When surveying for VoWLAN， which power level should you base the access point coverage designon？（）
Which two methods can be used to prevent or reduce RFI from colocated directional antennas（）
What is a site survey best practice for location-based services？（）
Which three items does the Cisco WCS Planning Tool Generate Proposal Report provide？（）
How is attenuation measured？（）
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920， 7921G， and7925G？（）
For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey， what are the mostappropriate client test settings to use with the AirMagnet site survey tool？（）
Which three device types are identified by Cisco Spectrum Expert Wi-Fi finding an Avg PulseDuration parameter？（）