A. show interfaces interface
B. show vlan bri
C. show interfaces interface switchport
D. show interface interface trunk
E. show interfaces vlan
您可能感興趣的試卷
你可能感興趣的試題
A. any-to-many communication model
B. delivery of packets to the group interface that is closest to the sending device
C. one-to-many communication model
D. the same address for multiple devices in the group
E. one-to-nearest communication model
F. a unique IPV6 address for each device in the group
A.HMAC-MD5
B.RSA
C.HMAC-SHA-1
D.DH1
E.DH2
A.reduced cost
B.bette rthroughput
C.increased security
D.scalability
E.reduced latency
F.broadband incompatibility
A. EIGRP converges fast RIP because of DUAL and backup routes that are stored in the topology table.
B. EIGRP uses a hello protocol to establish neighbor relationships
C. EIGRP uses split horizon and reverse poisoning to avoid routing loops.
D. EIGRP uses periodic updates to exchange routing information
E. EIGRP allows routers of different manufacturers to interoperate
F. EIGRP supports VLSM and authentication for routing updates.
G. EIGRP use a broadcast address to send routing information.
A. CHAP uses a two-way handshake
B. CHAP authentication periodically occurs after link establishment
C. CHAP has no protection from playback attacks
D. CHAP authentication is performed only upon link establishment
E. CHAP uses a three-way handshake
F. CHAP authentication passwords are sent in plaintext
最新試題
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）
What is the subnetwork address for a host with the IP address 201.100.5.68/28?（）
At which layer of the OSI model dose PPP perform?（）
At which layer of the OSI model is RSTP used to prevent loops?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
Which IPsec security protocol should be used when confidentiality is required?（）