多項選擇題Which two statements about using the CHAP authentication mechanism in a PPP link are true?()

A. CHAP uses a two-way handshake
B. CHAP authentication periodically occurs after link establishment
C. CHAP has no protection from playback attacks
D. CHAP authentication is performed only upon link establishment
E. CHAP uses a three-way handshake
F. CHAP authentication passwords are sent in plaintext


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題the network administrator has been asked to give reasons for moving from ipv4 to ipv6. what are two valid reasons for adopting ipv6 over ipv4?()

A. telnet access does not require a password
B. nat
C. no broadcast
D. chanage of destination address in the ipv6 header
E. chanage of source address in the ipv6 header
F. autoconfiguration

2.多項選擇題Which three approaches can be used while migrating from an IPV4 addressing scheme to an IPV6 scheme.()

A. statically map IPV4 address to IPV6 addresses
B. configuration IPv4 tunnels between IPV6 islands
C. use DHCPv6 to map IPV4 addresses to IPV6 addresses
D. use proxying and translation to translate IPV6 packets into IPV4 packets
E. configure IPV6 directly
F. enable dual-stack routing

3.多項選擇題Which two subnetworks would be included in the summarized address of 172.31.80.0 /20?()

A.172.31.17.4/30
B.172.31.51.16/30
C.172.31.64.0/18
D.172.31.80.0/22
E.172.31.92.0/22
F.172.31.192.0/18

4.多項選擇題What two statistics appear in show frame-relay map output?()

A. The number of FECN packets that are received by the router
B. The number of BECN packets that are received by the router
C. The ip address of the local router
D. The value of the local DLCI
E. The status of the PVC that is configured on the router

5.多項選擇題It has become necessary to configure an existing serial interface to accept a second Frame Relay virtual circuit.Which of the following processes are required to accomplish this task?()

A. configure static frame relay map entries for each subinterface network.
B. remove the ip address from the physical interface
C. create the virtual interfaces with the interface command
D. configure each subinterface with its own IP address
E. disable split horizon to prevent routing loops between the subinterface networks
F. encapsulate the physical interface with multipoint PPP

最新試題

While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()

題型:單項選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:單項選擇題

When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()

題型:單項選擇題

Which statement describes the rule of split horizon?()

題型:單項選擇題

If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()

題型:單項選擇題

Which command is used to display the collection of OSPF link states?()

題型:單項選擇題

A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題

How are VTP advertisements delivered to switches across the network?()

題型:單項選擇題

Which statement is true, as relates to classful or classless routing?()

題型:單項選擇題