A. data link
B. network
C. physical
D. transport
您可能感興趣的試卷
你可能感興趣的試題
A. PSK
B. AH
C. MD5
D. ESP
A. show frame-relay map
B. show frame-relay lmi
C. show inter serial
D. show frame-relay pvc
A. B514:82C3:0029::EC7A:0000:EC72
B. B514:82C3:0029:EC7A:EC72
C. B514:82C3::0029:EC7A:0:EC72
D. B514:82C3::0029:EC7A:EC72
A. They run a spell check on host names to ensure accurate routing
B. They convert domain names into IP address
C. Given an IP address,they determine the name of the host that is sought
D. They map individual hosts to their specific IP addresses
A. VTP
B. 802.1Q
C. RSTP
D. STP
最新試題
What is the subnetwork address for a host with the IP address 201.100.5.68/28?()
At which layer of the OSI model dose PPP perform?()
What is the default administrative distance of OSPF?()
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
Which command displays the CHAP authentication process as it occurs between two routers?()
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
At which layer of the OSI model is RSTP used to prevent loops?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0