A.too much cooling water going through the condenser
B.not enough refrigerant in the system
C.a leak in the evaporator coils
D.no enough cooling water going through the condenser
您可能感興趣的試卷
你可能感興趣的試題
A.king valve and the expansion valve
B.solenoid valve and expansion valve
C.evaporator and receiver
D.compressor and evaporator
A.discharge side of condenser
B.discharge side of compressor
C.outlet of the evaporator
D.receiver tank
A.increase the amount of cooling water to the condenser
B.decrease the amount of cooling water to the condenser
C.add more refrigerant to the system
D.remove some of the refrigerant from the system
A.the relief valve should open before the high-pressure cutout
B.the relief valve should open and let excess refrigerant go to receiver
C.the high-pressure cutout switch should operate before the relief valve opens
D.close in on the suction valve
A.finished joints
B.welded joints
C.ground joints
D.soldered joints
最新試題
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
The condensers located in various stages of a flash evaporator are cooled by（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
If separating effect is not good, which measure should be taken （）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
（） is not installed on the main switchboar.
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）