A.the relief valve should open before the high-pressure cutout
B.the relief valve should open and let excess refrigerant go to receiver
C.the high-pressure cutout switch should operate before the relief valve opens
D.close in on the suction valve
您可能感興趣的試卷
你可能感興趣的試題
A.finished joints
B.welded joints
C.ground joints
D.soldered joints
A.a clogged scale trap
B.air in the system
C.automatic controls not functioning properly
D.insufficient cooling water to the condenser
A.separating chamber
B.system of baffles
C.purge valve
D.vacuum reducing valve
A.saltwater side of the condenser
B.refrigerant side of the condenser
C.in the evaporator coils
D.in the suction strainer
A.cutout
B.pressure controller
C.controller switch
D.cutout switch
最新試題
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
Using a file without a handle may result in （）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?（）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）