A.increase the amount of cooling water to the condenser
B.decrease the amount of cooling water to the condenser
C.add more refrigerant to the system
D.remove some of the refrigerant from the system
您可能感興趣的試卷
你可能感興趣的試題
A.the relief valve should open before the high-pressure cutout
B.the relief valve should open and let excess refrigerant go to receiver
C.the high-pressure cutout switch should operate before the relief valve opens
D.close in on the suction valve
A.finished joints
B.welded joints
C.ground joints
D.soldered joints
A.a clogged scale trap
B.air in the system
C.automatic controls not functioning properly
D.insufficient cooling water to the condenser
A.separating chamber
B.system of baffles
C.purge valve
D.vacuum reducing valve
A.saltwater side of the condenser
B.refrigerant side of the condenser
C.in the evaporator coils
D.in the suction strainer
最新試題
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
The cetane rating of diesel fuel is an indication of the （）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
The ISPS Code consists of a mandatory section-Part A, which shows（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The main purpose of port State control is not to（）
Flame failure in an automatically fired auxiliary boiler can from a/an （）