A.diameter of the discharge piping, with all other factors remaining the same
B.diameter of the suction piping, with all other factors remaining the same
C.width of the impeller only
D.diameter of the impeller
您可能感興趣的試卷
你可能感興趣的試題
A.run continuously
B.not start
C.have high discharge pressure
D.short cycle on the high pressure switch
A.Electrical energy
B.Thermal energy
C.Potential energy
D.Kinetic energy
A.sliding block
B.pintle
C.reaction ring
D.tilting box or swash plate
A.overfeeding of the expansion valve
B.damage to the condenser
C.constant running of the compressor
D.flooding of the receiver
A.horsepower
B.work
C.heat
D.velocity
最新試題
A pressure drop through the refrigerant liquid line may cause （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
The general purpose of a heat exchanger is to （）.
A grease gun is generally used to lubricate a （）.
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
Thermostatic expansion valves can be adjusted for （）.
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.