A.the system is fully charged
B.there is air leaking in from the condenser
C.ice crystals are forming in the refrigerant
D.the system contains less than a full charge of refrigerant
您可能感興趣的試卷
你可能感興趣的試題
A.Simplex
B.Duplex
C.Canister
D.Bypass
A.condition of the expansion valve
B.moisture in the system
C.condition of the compressor suction valves
D.condenser temperature
A.trick wheel
B.accumulator
C.standby pump
D.telemotor
A.Open the bilge pump for inspection
B.Remove each of the manifold valves
C.Remove only the manifold valve to the affected bilge-well
D.Attempt to pump out another bilge well to determine if the entire system is affected
A.too much refrigerant in the system
B.oil entrained in the refrigerant
C.less than a full charge of refrigerant in the system
D.ice crystals forming in the refrigerant
最新試題
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
The major source of chemical contaminants in hydraulic fluid is （）.
Low compressor head pressure in a refrigeration system can be caused by（）.
When the steering gear is in operation, you should （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
Thermostatic expansion valves can be adjusted for （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）