A.enable self-healing.
B.configure location manager.
C.conduct client walkabout.
D.conduct radio scan.
您可能感興趣的試卷
你可能感興趣的試題
A.disable auto rf and configure manually.
B.disable all 802.11b data rates.
C.power access point to full power.
D.hard code the channel.
A.infrastructure devices to associate only to this ssid
B.enable ip redirection on this ssid
C.set data beacon rate
D.multiple basic service set identification （bssid）
E.set infrastructure ssid
A.eap-peap
B.eap-fast
C.eap-cisco wireless （leap）
D.eap-tls
E.eap-md5
A.15
B.10
C.1
D.5
You are conducting a cdp-based discovery using an edge switch for the seed. there is a router between the switch and the wlse. none of the access points are discovered， and the discovery log shows the switch is snmp unreachable.
What is the problem？（）
A.the snmp communities on the switch do not match the wlse.
B.the snmp communities on the access points do not match the wlse.
C.the snmp communities on the access points do not match the switch.
D.the snmp communities on the router do not match the wlse.
最新試題
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
You are trying to change the polling parameters used by the location manager via the Cisco WCS，and your request is being denied. What is wrong？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add？（）
If it is properly deployed， a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem？（）