A.300
B.448
C.664
D.1800
E.2400
您可能感興趣的試卷
你可能感興趣的試題
A.Report the problem to the FCC
B.Report the problem to the FAA
C.Remove channel 36 from the DCA channel list
D.Configure channel 36 to bond to channel 40 for a 40Mhz 802.11n channel
A.0.25 W
B.0.45 W
C.1 W
D.1.25 W
E.2.45 W
F.5.65 W
A.photographs
B.floor plans
C.wired network layout
D.blueprints
A.green
B.blue
C.yellow
D.red
E.purple
F.white
A.100 mW， 24 Mb/s
B.100 mW， 18 Mb/s
C.25 mW， 18 Mb/s
D.3.2 mW， 54 Mb/s
A.Fresnel units
B.decibels
C.EIRP
D.milliamperes
E.ohms
A.40mW maximum transmit power
B.average power level of the VoWLAN clients
C.100mW transmit power
D.lowest power level of the VoWLAN clients
A.1/6
B.1/4
C.1/3
D.1/2
A.20 percent cell overlap
B.four access points detecting a client at -76 dBm or better
C.10 percent cell overlap
D.three access points detecting a client at -75 dBm or better
A.In a multifloor building， the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor， without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork
最新試題
Which two methods can be used to prevent or reduce RFI from colocated directional antennas（）
Which three items should the site survey documentation include？（）
What should be done if Cisco Spectrum Expert Wi-Fi reports a channel utilization of 40 percent onchannel 36， from a source outside of the site？（）
When surveying for VoWLAN， which power level should you base the access point coverage designon？（）
When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G handset in amultifloor building with a WLAN that operates at an 11 MB/s data rate， how many decibelsreferenced to 1 milliwatt of same-channel separation are recommended between floors？（）
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas？（）
What will cause wireless voice devices to perform poorly？（）
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS？（）
Which can NOT be selected for supported services in Cisco WCS Planning Tool？（）
What is the minimum recommended access point overlap for voice roaming？（）