You need to configure two Company routers for high availability.
Which protocol enables a group of routers to form a single virtual router and use the real IP address of a router as the gateway address？ （）
A. HSRP
B. IRDP
C. Proxy ARP
D. GLBP
E. VRRP
F. None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
You have just purchased a new Cisco 3560 switch running the enhanced IOS and need configure it to be installed in a high availability network. On a 3560 EMI switch，
which three types of interfaces can be used to configure HSRP？（）
A. SVI interface
B. Access port
C. EtherChannel port channel
D. Loopback interface
E. Routed port
F. BVI interface
A. QoS classified at layer 3 using IP precedence or DSCP.
B. Guaranteed rate service.
C. Implemented using FIFO queues.
D. All traffic has an equal chance of being dropped.
The Company is rolling out Cisco’s Architecture for Voice， Video and Integrated Data （AVVID）.
Which of the following choices represent the fundamental intelligent network services in Cisco’s AVVID？ （）
A. Quality of Service （QoS）
B. Intelligent platforms
C. Mobility and scalability
D. Security
E. High availability
Refer to the exhibit.
What is the effect when the switchport priority extend cos 3 command is configured on the switch port interface connected to the IP phone？（）
A. The IP phone is enabled to override with aCoS value of 3 the existing CoS marking of the PC attached to the IP phone.
B. The switch will no longer tag incoming voice packets and will extend the trust boundary to the distribution layer switch.
C. RTP will be used to negotiate aCoS value based upon bandwidth utilization on the link.
D. Effectively， the trust boundary has been moved to the PC attached to the IP phone.
E. The computer is now establishing theCoS value and has effectively become the trust boundary.
Refer to the exhibit.
Which Catalyst switch interface command would be used to cause the switch to instruct the phone to override the incoming CoS from the PC before forwarding the packet to the switch？（）
A. mls qos cos 2 override
B. switchport priority extend cos 11
C. switchport priority extend trust
D. switchport priority extend none
E. mls qos cos 2
F. switchport priority extend cos 2
最新試題
Which router redundancy protocol cannot be configured for interface tracking？（）
Refer to the exhibit. For what purpose is the command show ip cef used？（）
Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （）
How are STP timers and state transitions affected when a topology change occurs in an STP environment？（）
Refer to the exhibit. Which statement is true about the output？（）
Which two statements are true when the extended system ID feature is enabled？ （）
What two things will occur when an edge port receives a BPDU？（）
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statements about the STP process for VLAN 200 are true？ （）
Which three statements about STP timers are true？（）
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）