A.802.1D and 802.1w interoperate only when the 802.1D STP domain supports rapid convergence.
B.Ports leading to 802.1D devices will run in compatibility mode, while the rest of the ports will run in 802.1w mode.
C.This is an invalid configuration and a partial migration cannot be done.
D.The bridge timers will be set to match the 802.1D devices.
E.A secondary root bridge will always be populated within the 802.1D domain.
F.If the root bridge is selected within the 802.1D domain, the whole STP domain will run in 802.1D compatibility mode.
G.In partially migrated 802.1w networks, it is recommended to keep the STP diameter below 4.
您可能感興趣的試卷
你可能感興趣的試題
A.The VSS switch must be the root bridge for all VLANs and is automatically designated.
B.The VSS switch is defined in RFC 4318 as a managed object.
C.The PAgP+ or LACP protocols are used to maintain the operational state of the VSS devices.
D.A VSS interoperates with a virtual port channel.
E.The 802.1Q or ISL protocols are used to maintain the operational state of the VSS devices.
F.A VSS increases the size of the spanning-tree domain.
Refer to the exhibit.From the MAC addresses shown in the command output,to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch?()
A.Fa6/28
B.Fa7/20
C.Gi3/7
D.Fa4/2
E.Fa4/14
F.Fa4/38
G.Fa6/38
H.Fa5/7
Refer to the exhibit. When applying this hierarchical policy map on the on the tunnel1 interface, you measure high jitter for traffic going through class 1234. What is the most likely cause of this jitter?()
A.The configuration of a hierarchical policy map on a tunnel interface is not supported.
B.Class 5555 and class 5554 are both taking up 100% of the bandwidth,leaving nothing for class 1234.
C.The burst size for the traffic shaping is wrongly configured to 15000;this would require an interface capable of sending at 150Mb/s.
D.The burst size for the traffic shaping has been wrongly configured;it should be set as low as possible.
E.The burst size for the traffic shaping has been wrongly configured;it should be set as high as possible.
最新試題
R1 will choose which path to reach 10.1.0.0?
what is the disadvantage of policing?
How should arouter that is being used in a Frame Relay network be configured to avoid split horizon issues from preventing routing updates?()
一堆交換機一個server、一個transpare,問配置prune在哪里配置?
four switches, which one will be root switch.(no pic).
what is the advantage of policing opposite to shaping?
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?()
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?()
什么問題導(dǎo)致SERVER VTP密碼跟替他交換機VTP密碼不匹配?
As a CCNA candidate,you must have a firm understanding of the IPv6 address structure.Refer to IPv6 address,could you tell me how many bits are included in each filed?()