A.VTPv3 supports 8K VLANs.
B.VTPv3 supports private VLAN mapping.
C.VTPv3 allows for domain discovery.
D.VTPv3 uses a primary server concept to avoid configuration revision issues.
E.VTPv3 is not compatible with VTPv1 or VTPv2.
F.VTPv3 has a hidden password option.
您可能感興趣的試卷
你可能感興趣的試題
A. interface bandwidth
B. interface delay
C. interface bandwidth and delay
D. hop count
E. bridge priority
A. Loop guard can be used with root guard simultaneously on the same port on the same VLAN while UDLD cannot
B. UDLD protects against STP failures caused by cabling problems that create one-way links.
C. Loop guard detects and protects against duplicate packets being received and transmitted on different ports
D. UDLD protects against unidirectional cabling problems on copper and fiber media.
E. Loop guard protects against STP failures caused by problems that result in the loss of BPDUs from a designated switch port.
A.followers field
B.MD5 digest
C.VLAN information
D.sequence number
Refer to the exhibit. In the diagram，the switches are running IEEE 802.1w RSPT. On which ports should root guard be enabled in order to facilitate deterministic root bridge election under normal and failure scenarios？（）
A. GE-3/1， GE-3/2
B. FE-2/1， FE-3/2
C. GE-1/1， GE-1/2
D. GE-4/1， GE-4/2
E. GE-2/1， GE-2/2
F. GE-3/1， GE-3/2， GE-4/1， GE-4/2， FE-2/1， FE-3/2
A.runts
B.FCS errors
C.interface resets
D.late collisions
最新試題
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain？（）
What is the correct command to set the router ID for an OSPFv3 process？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
All of these are fundamental building blocks of differentiated services Traffic Conditioner Block exceptwhich one？（）
What is true about Unicast RPF in strict mode？（）
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）