A.runts
B.FCS errors
C.interface resets
D.late collisions
您可能感興趣的試卷
你可能感興趣的試題
A.mpls ip cef
B.port-channel ip cef
C.mpls ip port-channel cef
D.port-channel load balance
E.mpls ip load-balance
F.ip cef EtherChannel channel-id XOR L4
G.ip cef connection exchange
Refer to the exhibit. In the diagram， the switches are running IEEE 802.1s MST. Which ports are in the MST blocking state？（）
A. GE-1/2 and GE 2/1
B. GE-1/1 and GE-2/2
C. GE-3/2 and GE 4/1
D. no ports are in the blocking state
E. There is not enough information to determine which ports are in the blocking state.
A.The originator of the TCN immediately floods this information through the network.
B.The TCN propagation is a two step process.
C.A TCN is generated and sent to the root bridge.
D.The root bridge must flood this information throughout the network.
Refer to the exhibit. Catalyst R is the root bridge for both VLAN 1 and VLAN 2.What is the easiest way to load-share traffic across both trunks and maintain redundancy in case a link fails，without using any type of EtherChannel link-bundling？（）
A. Increase the root bridge priority （increasing the numerical priority number） for VLAN 2 on Catalyst D so that port D2 becomes the root port on Catalyst D for VLAN 2.
B. Decrease the port priority on R2 for VLAN 2 on Catalyst R so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1.
C. Decrease the path cost on R2 on Catalyst R for VLAN 2 so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1.
D. Increase the root bridge priority （decreasing the numerical priority number） for VLAN 2 on Catalyst R so that R2 becomes the root port on Catalyst D for VLAN 2.
A.Loop guard only operates on interfaces that are considered point-to-point by the spanning tree.
B.Loop guard only operates on root ports.
C.Loop guard only operates on designated ports.
D.Loop guard only operates on edge ports.
最新試題
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）
Which three options are valid ways to filter routes from a BGP peer？（）
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
What is the correct command to set the router ID for an OSPFv3 process？（）
Which of these statements about penultimate hop popping are true？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
Which two statements are true about RED？（）