A.VTP
B.STP
C.ISL
D.802.1Q
E.VLSM
您可能感興趣的試卷
你可能感興趣的試題
A.buffering
B.cut-through
C.windowing
D.congestion avoidance
E.load balancing
A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 5
E.Layer 6
F.Layer 7
A.By default， all defined VLANs are allowed on the trunk.
B.Each single VLAN， or VLAN range， must be specified with the switchport mode command.
C.Each single VLAN， or VLAN range， must be specified with the vtp domain command.
D.Each single VLAN， or VLAN range， must be specified with the vlan database command.
A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.
A.A WPA key is longer and requires more special characters than the WEP key.
B.The access point and the client are manually configured with different WPA key values.
C.WPA key values remain the same until the client configuration is changed.
D.The values of WPA keys can change dynamically while the system is used.
最新試題
What is the default administrative distance of OSPF?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?（）
What is the subnetwork address for a host with the IP address 201.100.5.68/28?（）
Which pairing reflects a correct protocol-and-metric relationship?（）
Which command displays the CHAP authentication process as it occurs between two routers?（）
Which IPsec security protocol should be used when confidentiality is required?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）