A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 5
E.Layer 6
F.Layer 7
您可能感興趣的試卷
你可能感興趣的試題
A.By default， all defined VLANs are allowed on the trunk.
B.Each single VLAN， or VLAN range， must be specified with the switchport mode command.
C.Each single VLAN， or VLAN range， must be specified with the vtp domain command.
D.Each single VLAN， or VLAN range， must be specified with the vlan database command.
A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.
A.A WPA key is longer and requires more special characters than the WEP key.
B.The access point and the client are manually configured with different WPA key values.
C.WPA key values remain the same until the client configuration is changed.
D.The values of WPA keys can change dynamically while the system is used.
A.The router will use the static route.
B.The router will use the OSPF route.
C.The router will use the EIGRP route.
D.The router will load balance and use all three routes.
A.neighbor table
B.SPF table
C.RTP table
D.topology table
E.query table
F.DUAL table
最新試題
Which statement is true, as relates to classful or classless routing?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
What is the subnetwork address for a host with the IP address 201.100.5.68/28?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）