A.flushing separator with hot water
B.increasing water supply flow
C.heat oily water properly
D.opening manual oil discharge value
您可能感興趣的試卷
你可能感興趣的試題
A.the separator is overload
B.the monitor equipment of separator fails
C.the discharge pump of separator can not work
D.the temperature of oil water is low
A.15；inlet value
B.15；inlet and outlet value
C.30；inlet value
D.30；inlet and outlet value
A.filled with bilge water
B.filled with oil
C.filled with clean water
D.be emptied
A.the sensor of low oil level is fully covered by sludge
B.the coarse strainer before the pump in suction system is clogged
C.the screw pump is worn seriously and volumetric efficiency is decreased
D.bilge suction value is clogged
A.the filter is clogged
B.bilge suction value is clogged
C.suction value and discharge value of the pump do not open fully
D.screw pump is worn seriously and volumetric efficiency is decreased
最新試題
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The shipboard oil pollution emergency plan will be invalid after （）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.