A.the separator is overload
B.the monitor equipment of separator fails
C.the discharge pump of separator can not work
D.the temperature of oil water is low
您可能感興趣的試卷
你可能感興趣的試題
A.15;inlet value
B.15;inlet and outlet value
C.30;inlet value
D.30;inlet and outlet value
A.filled with bilge water
B.filled with oil
C.filled with clean water
D.be emptied
A.the sensor of low oil level is fully covered by sludge
B.the coarse strainer before the pump in suction system is clogged
C.the screw pump is worn seriously and volumetric efficiency is decreased
D.bilge suction value is clogged
A.the filter is clogged
B.bilge suction value is clogged
C.suction value and discharge value of the pump do not open fully
D.screw pump is worn seriously and volumetric efficiency is decreased
A.separating oil too fast
B.the sensor flushed badly
C.the discharge solenoid value out of order
D.too low heating temperature
![](https://static.ppkao.com/ppmg/img/appqrcode.png)
最新試題
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
The condensers located in various stages of a flash evaporator are cooled by()
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()
To proceed to the assistance of a ship in distress is()
Cold weather starting of a diesel engine may be made easier by()
During the diesel engine running, the water level of F.W expansion tank should normally kept in the () level of glass tube.
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
Which of the following items don’t belong to dock repair works?()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()