A.open
B.close
C.remain in its position
D.flood the evaporator with refrigerant
您可能感興趣的試卷
你可能感興趣的試題
A.low water level
B.low oil pressure
C.excessively high fuel pressure
D.an improper air/fuel ratio
A.Condenser leakage
B.A shortage of liquid refrigerant
C.Excessive frost on the evaporator
D.Not enough condenser cooling water
A.high discharge pressure
B.frosting of the crankcase
C.high temperature of the overboard water
D.low suction pressure of compressor
A.upper part of the receiver
B.upper part of the condenser
C.down stream end of the cooling coil
D.outlet end of the condenser
A.icing of the automatic controls
B.embrittlement of some parts of the automatic controls
C.sludge in the lubricating oil
D.all of the above
最新試題
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
The major source of chemical contaminants in hydraulic fluid is （）.
The general purpose of a heat exchanger is to （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
The usual symptoms of cavitation in a centrifugal pump is （）.