A. line timing
B. loop timing
C. internal timing
D. through timing
E. external timing
您可能感興趣的試卷
你可能感興趣的試題
A. 512
B. 255
C. 1024
D. 4096
You are installing a Cisco ONS 15454 SDH in a service provider site. An E3 cable is being connected to a digital cross-connect system.
What is the maximum distance allowed between the two？（）
A. 225 ft
B. 450 ft
C. 655 ft
D. 900 ft
A. An equal amount of working and protect bandwidth is required.
B. DCC bandwidth is not large enough to handle K1/K2 processing.
C. Switch times would exceed 50 ms for an STM-1 MS-SPRing ring.
D. There is not enough bandwidth in an STM-1 ring to justify MS-SPRing protection.
You are provisioning an E-1 circuit on an ONS 15454 SNCP configuration and XC-VXL-10G card.
How many total ports are used within the Low-Order matrix at the source node？（）
A. 0
B. 1
C. 2
D. 3
E. 5
A. It protects signals against node failures between rings.
B. It protects signals against node failure within a single ring.
C. It allows for traffic to be preempted when a ring switch occurs.
D. Traffic can be dropped and continued at interconnecting nodes.
E. It protects preemptible traffic from being dropped when a ring switch occurs.
最新試題
If the dispersion of a given fiber is 17ps/nm*km at 1550 nm and zero at 1310 nm， then what is the accumulated dispersion of an ITU wavelength after it travels 200 km？ （）
In SDH， what is the name of the embedded Data Communication Channel （DCC） in bytes D1-D3？（）
What are two major differences between MS-SPRing and SNCP？（）
A 2.5 Gb/s （OC-48 or STM-16） optical signal with a dispersion tolerance of 1200 ps/nm goes through fiber with 18ps/nm*km of dispersion. How many 15216-DCU-350 equivalents are needed for enough compensation after traveling 100 km？（）
Click the Exhibit button. Within an ONS 15454， you are provisioning a circuit on an unprotected SNCP ring. In the exhibit， which two must you configure？（）
Which three technologies are used to reduce chromatic dispersion accumulation in fiber-optic transmission systems？（）
What protection method is used in 4F MS-SPRing networks？（）
Which device creates an OEO conversion？ （）
Given the formula： （Fiber Attenuation * Km） + （Splice Attenuation * # of Splices） + （Connector Attenuation * # of Connectors） + （Optical Fiber or OADM） + Buffer（Fiber aging）） With regard to SONET/SDH optical calculations， what will the given formula provide？（）
Click the Exhibit button. When designing a DWDM system with multiple amplified spans， a pre-amp is needed at Site B to （）.