A.IGMP Snooping
B.WMM
C.QoS Element for Wireless Phones
D.AVVID Priority Mapping
您可能感興趣的試卷
你可能感興趣的試題
A.Systems Integration
B.Skill Assessment
C.Systems Acceptance Testing
D.Wireless Check
E.Project Close Out
When optimizing a standalone point-to-multipoint bridge installation with eight non-root bridges.
Which of the following RTS threshold and CWmin settings would be correct for the non-root bridges？（）
A.RTS threshold = 1，CWmin = 4
B.RTS threshold = 4000，CWmin = 5
C.RTS threshold = 4000，CWmin = 3
D.RTS threshold = 1，CWmin = 5
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror."
Which failure could produce this error？（）
A.AAA client and AAA server handshake failure
B.supplicant authentication failure
C.wrong password used by the supplicant
D.failure of the wireless client and AAA server handshake
During the installation of the Cisco WCS version 4.0， an error occurs.
Where would you look forthe installation log，in order to learn more about this error？（）
A.at the root of the installation drive
B.in the Cisco WCS installation directory
C.on the desktop of the server
D.in the Cisco WCS\Logs directory
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.
What is the maximum number of WLAN controllers that you can add？（）
A.17
B.20
C.12
D.24
最新試題
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）