A.client traffic allowed， data captured on all channels
B.client traffic allowed， data captured on a single channel
C.no client traffic allowed， data captured on a single channel
D.no client traffic allowed， data captured on all channels
您可能感興趣的試卷
你可能感興趣的試題
You are installing a cisco 4402 series wireless lan controller.
What type of interface is used on the uplink port？（）
A.1000base-x mini-gbic
B.10/100/1000 mbps rj45
C.10/100 mbps rj45
D.1000base-sx
A.interference，utilization，and rf diffraction
B.clients，utilization，and multipath interference
C.noise，interference，and coverage holes
D.noise interference，and multipath interference
Static wep is configured on the access point. you are authenticated and associated to the access point but are unable to obtain an ip address.
Which of the following will cause this problem？（）
A.invalid radio type selected
B.no wep key configured on the client
C.invalid ssid configured
D.invalid wep key
An reap was supporting 16 wlans， but now it only supports one.
What happened to cause the change？（）
A.controller connectivity has been lost.
B.the access point lost its configuration.
C.the access point was rebooted.
D.an access point firmware upgrade is in progress.
A rogue access point is detected on the cisco wcs consolE. upon investigation，the access point is discovered to belong to a neighboring business.
Your administrator should designate the rogue access point as which of the following？（）
A.known internal
B.managed
C.friendly
D.known external
最新試題
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
On a WLAN controller， what is the default roaming bandwidth percentage reserved for voice clients？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped.What may cause this problem？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）