On a cisco aironet 1130ag series standalone access point,the status led is dark blue and blinking.
What does this indicate？（）
A.the internal radio has failed.
B.a firmware upgrade is in progress.
C.an access point buffer overflow is occurring.
D.the access point is booting.
您可能感興趣的試卷
你可能感興趣的試題
In a deployment using standalone access points， clients set up to authenticate with eap-peap or eap-cisco wireless （cisco-leap） cannot authenticatE. when you inspect the failed attempts report on the cisco secure acs， you find this error： "unknown network access server nas."
Which problem may have caused this failure？（）
A.misconfigured ip address of the aaa server on the access point
B.misconfigured eap type on the access point
C.misconfigured ip address of the access point on the aaa server
D.misconfigured eap type on the aaa server
A.router （config-ssid）# guest-mode
B.router （config-ssid）# advertise
C.router （config-ssid）# enable
D.router （config-ssid）# broadcast
Yours truly，customer has deployed a cisco wireless location appliance within its warehouse
environment. however， employees there have been experiencing problems when tracking objects using active rfid tags. the rfid tag data is not being collected.
On which device would you verify that rfids have been enabled？（）
A.access point
B.location manager
C.wireless controller
D.cisco wcs
A.partners having a discussion with customers about the minimum service components needed to successfully deploy a wireless solution
B.customers determining a competitor’s strategy for adopting advanced technologies
C.partners choosing the right products for their customers
D.customers choosing the right products for their network
E.customers defining the correct strategy for advanced technology adoption
A.five
B.three
C.six
D.four
最新試題
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it， allthe LEDs on the access point blink together.What does this indicate about the access point？（）
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking，but the status LED and Ethernet LED are both off.What does this indicate？（）
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）