A.passed by the AP to its connected switch and then forwarded directly to the connected router，which creates an MGID table entry
B.passed by the AP to the WLAN controller and then forwarded to the source PIM-enabled router，which creates an MGID table entry
C.passed by the AP to the WLAN controller， which creates an MGID table entry before forwarding to the directly connected PIM-enabled router
D.passed by the AP to its connected switch and then forwarded to the rendezvous point router，which creates an MGID table entry
您可能感興趣的試卷
你可能感興趣的試題
A.to determine if there are more clients that are using the multicast stream
B.to limit the time that a client has to request an IGMP join to the controller multicast group
C.to determine if the multicast router is still alive and responding to multicast clients
D.to remove clients from the multicast group if the multicast traffic exceeds the allotted bandwidth allowed for multicast clients
A.TSPEC IE
B.TSRS IE
C.WMM IE
D.TSM IE
A.Wireless client WMM UP classification is translated to a wired DSCP priority.
B.Wireless client 802.11p classification is translated to a wired DSCP priority.
C.Wireless client WMM UP classification is translated to a wired 802.1p CoS priority.
D.Wireless client 802.11p classification is translated to a wired 802.1p CoS priority.
A.Packet loss is less than one percent.
B.Signal strength at cell edge is approximately -67 dBm.
C.End-to-end delay is less than 200 ms.
D.Cell overlap between APs is 50 percent.
A.the codec used by the calling phone
B.approximate length of the call in minutes
C.MOS values throughout the duration of the call
D.802.11e access category overruns
E.co-channel interference percentage during the call
最新試題
What call performance statistics are reported on the Cisco Wireless IP Phone 7921 user interface?（）
Which deployed VoWLAN client security option is recommended by Cisco?（）
What is the payload size of a wireless IP phone in a call using G.711 codec?（）
When designing the coverage area for high call capacity, what two actions should be done with data rates and channels?（）
What is the WMM user priority of the packets going downstream to the client when the client does not support TSPEC but the Cisco WLC has ACM enabled and WLAN priority is set to Platinum?（）
Which two statements correctly describe a Cisco WLC configuration of Wireless > QoS > Profiles >Wired_QoS_Profiles for an implementation of DSCP or CoS deployment?（）
How do Cisco Unified Communications IP phones receive firmware upgrades?（）
What is the Cisco recommended setting for the Cisco Unified Wireless Network WLC Voice Call Admission Control Max RF Bandwidth to support the Cisco Unified Wireless IP Phone 7921G?（）
Which three solutions does AirMagnet VoFi Pro Analyzer integrate?（）
Which three statements are true about load-based Call Admission Control?（）