A. It is achieved by using more than one HSRP group.
B. It is done in regards to either round robin or weight basis.
C. It is used to offload the active router in a certain HSRP group.
D. Single group HSRP is used to achieve more efficient link utilization.
E. The return traffic is influenced by HSRP load sharing configuration.
您可能感興趣的試卷
你可能感興趣的試題
A. interface vlan 100 ip access-group test
B. interface vlan 100 ip access-group test in
C. interface vlan 100 ip access-group test out
D. vlan filter test vlan-list 100
E. vlan access-map test 100
A. no single point of failure
B. trading database server location
C. redundant application servers location
D. deterministic response to all failures
E. determine which protocol to use
A. Cisco VAM2+
B. Cisco Network Assistant
C. Cisco SDM
D. Cisco IPS
A. mode sso, redundancy, show redundancy states
B. show redundancy states, mode sso, redundancy
C. redundancy, mode sso, show redundancy states
D. show redundancy states, redundancy, mode sso
Refer to the exhibit. For interface FastEthernet0/0, what will happen to dscp af11 traffic if the queue for class "newclass" reaches a depth of 40? （）
A. All packets will be dropped.
B. One out of ten packets will be dropped.
C. A random number of packets will be dropped.
D. No packets will be dropped until the queue depth reaches 265.
E. Packets will be dropped according to the exponential weight setting.
最新試題
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?（）
Which three of these items are IPv6 transition mechanisms? （）(Choose three.)
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）
With a VPN Accelerator Module 2+ (VAM2+) installed in a Cisco 7200 series router, what will be the resulting action when entering the command no crypto engine accelerator slot number?（）
You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?（）
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
What is the purpose of using VPN hardware acceleration equipment?（）
In a RSTP implementation, which of the following two link types are used? （）(Choose two.)
You are an experienced network administrator in an international corporation. During your working hours, you are asked to deploy the Cisco SSL VPN AIM module in a Cisco 1800 Series Router. The beneficial reason for that deployment is to:（）