A. IS-IS, EIGRP, SSO, BGP
B. ISSU, OSPF, IS-IS
C. IETF, OSPF, ISSU
D. EIGRP, BGP, OSPF, IS-IS
您可能感興趣的試卷
你可能感興趣的試題
A. An information trap is sent to the SNMP server.
B. Informational and debug messages are logged to the syslog server.
C. All messages are sent to the logging host, where selections are made.
D. All messages from emergencies to informational are sent to the logging host.
A. reset of the primary supervisor
B. manual switchover from standby to active supervisor
C. manual switchover from active to standby supervisor
D. automatic switchover from active to standby on primary supervisor failure
A.Implement
B.Design
C.Prepare
D.Operate
Refer to the exhibit. For interface FastEthernet0/0, what will happen to dscp af11 traffic if thequeue for class "newclass" reaches a depth of 32? （）
A. All packets will be dropped.
B. One out of ten packets will be dropped.
C. A random number of packets will be dropped.
D. No packets will be dropped until the queue depth reaches 40.
E. Packets will be dropped according to the exponential weight setting.
Refer to the exhibit. Users complain that they intermittently lose data and connections toimportant servers. After investigation, you discover that the 802.1Q trunk between DSW111 andASW1 is down. Even though the HSRP group 11 is being serviced by DSW112, you discover thatthe SVI for VLAN 11 is in the up state on DSW111. Which three Cisco Catalyst IOS commands
should you use on DSW111 to find the source of this problem? （）(Choose three.)
A. show vtp status
B. show interfaces vlan 11
C. show standby vlan 11 brief
D. show spanning-tree vlan 11
E. show interfaces
最新試題
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?（）
Which three of these items are IPv6 transition mechanisms? （）(Choose three.)
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?（）
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)
Refer to the exhibit. Which two of these events will be the result of issuing the above command? （）(Choose two.)
You are an experienced network administrator in an international corporation. During your working hours, you are asked to deploy the Cisco SSL VPN AIM module in a Cisco 1800 Series Router. The beneficial reason for that deployment is to:（）
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.Which two best-practice actions can you take to overcome this problem? （）(Choose two.)