An SVI has been configured on a device.
Which two statements are true about a switched virtual interface （SVI）？（）
A.An SVI is normally created for the default VLAN （VLAN1） to permit remote switch administration.
B.Multiple SVIs can be associated with a VLAN.
C.SVI is another name for a routed port.
D.An SVI is created by entering the no switchport command in interface configuration mode.
E.An SVI provides a default gateway for a VLAN.
您可能感興趣的試卷
你可能感興趣的試題
The following output was displayed on a switch.
Study the exhibit carefully. The administrator is verifying that a CEF FIB entry exists to destination network 192.168.150.0. Given the output generated by the "show ip cef" and "show adjacency detail" commands，
which three statements are true？ （）
A.The "valid cached adjacency" entry indicates that CEF will put all packets going to such an adjacency to the next best switching mode.
B.The number 003071506800 is the MAC address of the source IP address.
C.There is a valid CEF entry for the destination network 192.168.150.0.
D.The number 003071506800 is the MAC address of the 192.168.199.3 next hop IP address.
E.The counters （0 packets， 0 bytes） indicate a problem with the 192.168.199.3 next hop IP address.
F.There is an adjacency for the 192.168.199.3 next hop IP address.
You work as a network technician at. Your boss， Mrs. ， is interested in the Spanning Tree Protocol timers.
What can you tell her regarding the default STP timers？ （）
A.The hello time is 5 seconds.
B.The forward delay is 10 seconds.
C.The hello time is 2 seconds.
D.The forward delay is 15 seconds
E.The max_age timer is 15 seconds.
F.The hello time is 10 seconds.
G.The max_age timer is 20 seconds.
H.The forward delay is 20 seconds.
I.The max_age timer is 30 seconds.
A switch port on TK1 is being configured to support 802.1Q trunking.
Which of the following are true about 802.1Q trunking？（）
A.Both switches must be in the same VTP domain.
B.The encapsulation type of both ends of the trunk does not have to match.
C.The native VLAN on both ends of the trunk must be VLAN 1.
D.802.1Q trunking can only be configured on a Layer 2 port.
E.In 802.1Q trunking， all VLAN packets are tagged on the trunk link， except the native VLAN.
A.forwarding information base
B.adjacency tables
C.neighbor tables
D.caching tables
E.route tables
A.Address Resolution Protocol （ARP）
B.PDU header rewrite
C.NetFlow switching
D.hello packet exchange
最新試題
Which statement is correct about the use of the virtual interface on a WLC ？（）
Which two statements about the various implementations of STP are true？（）
During routine maintenance， it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time， DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ？ （）
DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ？ （）
Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result？（）
Which two statements are true when the extended system ID feature is enabled？ （）
How are STP timers and state transitions affected when a topology change occurs in an STP environment？（）
Which router redundancy protocol cannot be configured for interface tracking？（）