Exhibit：
You work as a network administrator at. You study the exhibit carefully.
Which configuration on the HSRP neighboring device ensures that it becomes the active HSRP device in the event that port fa1/1 on 1 goes down？ （）
A. 2（config-if）#ip address 10.10.10.2 255.255.255.0 2（config-if）#standby 1 priority 200 2（config-if）#standby 1 ip 10.10.10.10
B. 2（config-if）# ip address 10.10.10.2 255.255.255.0 2（config-if）#standby 1 priority 195 2（config-if）#standby 1 preempt 2（config-if）#standby 1 ip 10.10.10.10
C. 2（config-if）# ip address 10.10.10.2 255.255.255.0 2（config-if）#standby 1 priority 190 2（config-if）#standby 1 ip 10.10.10.10 2（config-if）#standby 1 track interface fa 1/1
D. 2（config-if）# ip address 10.10.10.2 255.255.255.0 2（config-if）#standby 1 priority 200 2（config-if）#standby 1 preempt 2（config-if）#standby 1 ip 10.10.10.10 2（config-if）#standby 1 track interface fa 1/1
您可能感興趣的試卷
你可能感興趣的試題
You have configured the "config network webmode enable" command on a Cisco device.
What is the purpose of this command？ （）
A.To allow HTTP access to the WLAN controller
B.To allow SSH access to the CLI of the WLAN controller
C.To allow SSL access to the CLI of the WLAN controller
D.To allow HTTPS access to the WLAN controller
E.None of the other alternatives apply
A.When the voice VLAN feature is enabled， all untagged voice and data traffic is sent through the voice VLAN.
B.The voice VLAN feature is enabled by default.
C.The IP phone overrides the priority of all incoming data traffic （tagged and untagged） and sets the CoS value to 0.
D.The default CoS value is 1 for incoming voice and data traffic.
You work as a network engineer for. You study the exhibit carefully.
What type of attack would be mitigated by this configuration？（）
A.CDP manipulation
B.VLAN hopping
C.MAC spoofing
D.MAC flood attack
E.ARP spoofing
F.spanning tree compromises
You want to enhance the security within the LAN and prevent VLAN hopping.
What two steps can be taken to help prevent this？（）
A.Enable BPD guard
B.Disable CDP on ports where it is not necessary
C.Place unused ports in a common unrouted VLAN
D.Prevent automatic trunk configuration
E.Implement port security
The network administrator has enabled BPDU guard on the LAN.
Why is an effective way to prevent an unauthorized rogue switch from altering the spanning-tree topology of this network？ （）
A.BPDU guard can be used to prevent invalid BPDUs from propagating throughout the network.
B.BPDU guard can guarantee proper selection of the root bridge.
C.BPDU guard can be utilized to prevent the switch from transmitteing BPDUs and incorrectly altering the root bridge election.
D.BPDU guard can be utilized along with PortFast to shut down ports when a switch is connected to the port.
E.None of the other alternatives apply
最新試題
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2？（）
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this？（）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）
Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statements about the STP process for VLAN 200 are true？ （）
Which router redundancy protocol cannot be configured for interface tracking？（）
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command， which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true？（）
Refer to the exhibit. For what purpose is the command show ip cef used？（）
Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1？ （）