A.AlarmSeverity
B.AlarmKeepalive
C.AlarmTraits
D.EventMedia
E.EventAlarm
F.EventAction
您可能感興趣的試卷
你可能感興趣的試題
A.Cable modems only operate at Layer 1 of the OSI model.
B.Cable modems operate at Layers 1 and 2 of the OSI model.
C.Cable modems operate at Layers 1， 2， and 3 of the OSI model.
D.A function of the cable modem termination system （CMTS） is to convert the modulated signal from the cable modem into a digital signal.
E.A function of the cable modem termination system is to convert the digital data stream from the end user host into a modulated RF signal for transmission onto the cable system.
A.Dead Peer Detection （DPD）
B.CDP
C.isakmp keepalives
D.GRE keepalive mechanism
E.The hello mechanism of the routing protocol across the IPsec tunnel
Refer to the exhibit. Which statement is true about the partial MPLS configuration that is shown？（）
A.The route-target both 100：2 command sets import and export route-targets for vrf2.
B.The route-target both 100：2 command changes a VPNv4 route to a IPv4 route.
C.The route-target import 100：1 command sets import route-targets routes specified by the route map.
D.The route-target import 100：1 command sets import route-targets for vrf2 that override the other route-target configuration.
Refer to the exhibit. Which statement is true about the configuration of split tunnels using SDM？（）
A.Any protected subnets that are entered represent subnets at the end user’s site that will be accessed without going through the encrypted tunnel.
B.Any protected subnets that are entered represent subnets at the end user’s site that will be accessed through the encrypted tunnel.
C.Any protected subnets that are entered represent subnets at the VPN server site that will be accessed without going through the encrypted tunnel.
D.Any protected subnets that are entered represent subnets at the VPN server site that will be accessedthrough the encrypted tunnel.
A.All passwords entered during the AutoSecure configuration must be a minimum of 8 characters in length.
B.Cisco123 would be a valid password for both the enable password and the enable secret commands.
C.The auto secure command can be used to secure the router login as well as the NTP and SSH protocols.
D.For an interactive full session of AutoSecure， the auto secure login command should be used.
E.If the SSH server was configured， the 1024 bit RSA keys are generated after the auto secure commandis enabled.
最新試題
What are the four fields in an MPLS label？（）
Refer to the exhibit.What does the "26" in the first two hop outputs indicate？（）
Refer to the exhibit. Which order correctly identifies the steps to provision a cable modem to connect to a headend as defined by the DOCSIS standard？（）
Which statement describes Reverse Route Injection （RRI）？（）
What is a reason for implementing MPLS in a network？（）
Which three statements about the Cisco Easy VPN feature are true？（）
Refer to the exhibit.Which three statements describe the steps that are required to configure an IPsec site-to-site VPN using a GRE tunnel？（）
Refer to the exhibit. The show mpls interfaces detail command has been used to display information about the interfaces on router R1 that have been configured for label switching. Which statement is true about the MPLS edge router R1?（）
Refer to the exhibit. Which statement about the authentication process is true？（）
Which statement about an IPS is true？（）