A. ::/0 is the default route, and ::/128 is the unspecified address.
B. ::/0 is the unicast address, and ::/128 is the anycast address.
C. ::/0 is the anycast address, and ::/128 is the multicast address.
D. ::/0 is the unicast address, and ::/12 8 is the multicast address.
E. ::/0 is the unspecified address, and ::/128 is the multicast address.
F. ::/0 is the anycast address, and ::/128 is the default address.
您可能感興趣的試卷
你可能感興趣的試題
A. Every 16 - bit segment segment that consists of all zeroes can be represented with a single colon.
B. The trailing zeroes in any 16 - bit segment do not have to be written.
C. The leading zeroes in any 16 - bit segment do not have to be written.
D. Any single, continuous string of one or more 16 - bit segments that consists of all zeroes can be represented with a double colon.
E. The maximum number of times a double colon can replace a 16 - bit segment that consists of all zeroes is two.
F. Two zeroes in the middle of any 16 -bit segment do not have to be written.
A. The network was originated via redistribution of an interior gateway protocol into BGP.
B. The network was defined by a static route.
C. The network was learned via IBGP.
D. The network was learned via EBGP.
E. The network was originated via a network or aggregate command.
A. Within an AS, all routers must run either BGP or IBGP.
B. An AS uses exterior gatew ay protocols (EGPs) to exchange information with other autonomous systems.
C. An AS is a group of routers under the same technical administration.
D. Within an AS, routes learned through BGP can be redistributed using interior gateway protocols.
E. Wi thin an AS, routes learned through an interior protocol cannot be redistributed using BGP to other autonomous systems.
A. The IBGP neighbor is not directly connected.
B. BGP synchronization is enabled in a transit autonomous system with fully - meshed IBGP neighbors.
C. The EBGP neighbor ebgp - multihop option is set to the de fault value.
D. The BGP update interval is different between the two BGP neighbors.
E. The BGP neighbor is referencing an incorrect autonomous system number in its neighbor statement.
F. There is an access list blocking all TCP traffic between the two BGP neighbors.
A. show ip bgp paths
B. show ip bgp peers
C. show ip bgp
D. show ip bgp summary
最新試題
Which of the following is the shortest valid abbreviation for FE80:0000:0000:0000:0010:0000:0000:0123?（）
The following output on Router R1 lists details of a BGP route for 190.1.0.0/16. Which of the following is true based on this output?（）R1# show ip bgp 19 0.1.0.0/16BGP routing table entry for 190.1.0.0/16, version 121Paths: (1 available, best #1, table Default - IP - Routing - Table)Advertised to update - groups:11 2 3 41.1.1.1 from 2.2.2.2 (3.3.3.3)Origin IGP, metric 0, localpref 100, valid, internal, best
Router R1 lists the following output from a show command. Which of the following is true about R1?（）R1# show ip v6 interface f0/0FastEthernet0/0 is up, line protocol is upIPv6 is enabled, link - local address is FE80::213:19FF:FE12:3456No Virtual link - local address(es):Global unicast address(es):2000::4:213:19FF:FE12:3456, subnet is 2000:0:0:4::/64 [EUI]Jo ined group address(es):FF02::1FF02::2FF02::1:FF:12:3456
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exis ts in a planning document intended to be used to copy/paste into Router R1 to enable EIGRP for IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about EIGRP for IPv6 on R1 after this configuration has been pasted into R1?（）ipv6 router eigrp 1ipv6 unicast- routinginterface f0/0ipv6 address 2000::1/64ipv6 eigrp 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 eigrp 1
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable RIPng and IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Which of the following is true about RIPng on R1 after this configuration has been pasted into R1?（）ipv6 unicast- routinginterface f0/0ipv6 rip one enableipv6 address 2000::1/64interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 rip one enable
Router R1 has two LAN interfaces and three serial interfaces enabled for IPv6. All the inte rfaces use link local addresses automatically generated by the router.Which of the following could be the link local address of R1's interface S0/0?（）
Router R1 sits at an Enterprise branch office, using the Internet for its only connectivity back to the rest of the EnterprisE.Which of the following is not a ben efit of using an IPsec tunnel for packets sent through the Internet, between R1 and the rest of the Enterprise?（）
Which of the following is helpful to allow an IPv6 host to learn the IP address of a default gateway on its subnet?（）
Look at the following configuration below and select the statements that are true.（）RD2(config)#router ospf 100RD2(config - router)# distance 180 10.1.10.1 0.0.0.0 match - meRD2(config -router)#!RD2(config - router) #ip access - list standard match - meRD2(config - std - nacl)# permit host 172.16.0.0
The following line of output was gathered on Enterprise Router Ent1 using the command show ip route. Which of the following answers is most likely to be true, based on thi s output？（）B 128.107.0.0 [20/10] via 11.11.11.11, 00:02:18