According to the information presented in the following exhibit， can you tell me the reason that thetrust state of interface FastEthernet 0/3 displays "not trusted"？（）
A.The command mis qos needs to be turned on in global configuration mode
B.DSCP map needs to be configured for VOIP
C.ToS has not been configured
D.There is not a Cisco Phone attached to the interface
您可能感興趣的試卷
你可能感興趣的試題
A.Variable queue delays
B.Packet drops
C.Transmitting too many small packets
D.Compression
A.Mis-routed packets
B.Excess jitter
C.Delay of critical traffic
D.Packet loss due to congestion
E.Data link layer broadcast storms
F.FTP connections unsuccessful
Refer to the exhibit. What is the effect when the switchport priority extend cos 3 command isconfigured on the switch port interface connected to the IP phone？（）
A.Effectively， the trust boundary has been moved to the PC attached to the IP phone
B.The computer is now establishing theCoS value and has effectively become the trust boundary
C.The IP phone is enabled to override with aCoS value of 3 the existing CoS marking of the PCattached to the IP phone
D.The switch will no longer tag incoming voice packets and will extend the trust boundary to thedistribution layer switch
E.RTP will be used to negotiate aCoS value based upon bandwidth utilization on the link
Based on the graphic below， which Catalyst switch interface command should be issued in orderfor the switch to instruct the phone to override the incoming CoS from the CK-PC before sendingthe packet to the switch？（）
A.switchport priority extend cos 11
B.switchport priority extend cos 2
C.mis qos cos 2
D.mis qos cos 2 override
A.switchport voice vlan vlan-id
B.mls qos trust device cisco-phone
C.switchport priority extend cos_value
D.mls qos trust cos
E.mls qos trust override cos
最新試題
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Drag the DSL local loop topic on the left to the correct descriptions on the right.
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Which statement correctly describes IPsec VPN backup technology？（）
Drag and drop question. The upper gives the MPLS functions， the bottom describes the planes.Drag the above items to the proper location at the below