A.In a 6to4 tunnel， the first two bytes of the IPv6 address will be 0x2002 and the next four byteswill be the hexadecimal equivalent of the IPv4 address
B.In a 6to4 tunnel， the IPv4 address 192.168.99.1 would be converted to the2002：1315：4463：1：：/64 IPv6 address
C.In a 6to4 tunnel， the IPv4 address 192.168.99.1 would be converted to the 2002：c0a8：6301：：/48IPv6 address
D.In a 6to4 tunnel， the first two bytes of the IPv6 address will be locally derived and the next twobytes will be the hexadecimal equivalent of the IPv4 address
E.In a 6to4 tunnel， the IPv4 address 192.168.99.1 would be converted to the 2002：c0a8：6301：：/16IPv6 address
您可能感興趣的試卷
你可能感興趣的試題
A.6to4 is a manual tunnel method
B.Prepending a reserved IPv6 code to the hexadecimal representation of 192.168.0.1 facilitates6to4 tunneling
C.Each 6to4 site receives a /48 prefix in a 6to4 tunnel
D.2002：：/48 is the address range specifically assigned to 6to4
E.Prepending 0x2002 with the IPv4 address creates an IPv6 address that is used in 6to4tunneling
A.Only OSPF version 3 can be utilized for routing IPv4 and IPv6
B.IPv4 and IPv6 networks can be routed simultaneously
C.IPv6 can be routed using the same routing protocol versions as IPv4
D.A router routing for IPv6 and IPv4 must convert IPv4 packets to IPv6 packets to route them
E.None of the other alternatives apply
A.192.168.30.1：0：0：0：0：0：0
B.0：0：0：0：0：0：192.168.30.1
C.：：192.168.30.1
D.C0A8：1E01：：
E.192.168.30.1：：
F.：：C0A8：1E01
A.The route table is cleared. Then the OSPF neighbors are reformed
B.The OSPF adjacencies are cleared and initiated again
C.The OSPF database is repopulated and then the shortest path first （SPF） algorithm isperformed.
D.The shortest path first （SPF） algorithm is performed on the LSA database
E.None of the other alternatives apply
Refer to the exhibit. What two statements are true？（）
A.The IP address of the backup designated router （BDR） is FE80：：205：5FFF：FED3：5808
B.This is the designated router （DR） on the FastEthernet 0/0 link
C.Interface FastEthernet 0/0 was configured with the ipv6 ospf 1 area 1 command
D.OSPF version 2 has been enabled to support IPv6
E.The output was generated by the show ip interface command
最新試題
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.（Not allstatements will be used）
Match the xDSL type on the above to the most appropriate implementation on the below.
Drag and drop each management protocol on the above to the correct category on the below.
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
Which statement about PPPoA configuration is correct？（）
Which statement correctly describes IPsec VPN backup technology？（）