Refer to the exhibit. Which two problems are the most likely cause of the exhibited output？（）
A.VRRP misconfiguration
B.spanning tree issues
C.transport layer issues
D.physical layer issues
E.HSRP misconfiguration
您可能感興趣的試卷
你可能感興趣的試題
Examine the router output above. Which two items are correct？（）
A.If Ethernet 0/2 goesdown， the standby router will take over
B.The local IP address of Router A is 10.1.0.6
C.When Ethernet 0/3 of RouterA comes back up， the priority will become 105
D.Router A will assume the active state if its priority is the highest
E.The local IP address of Router A is 10.1.0.20
What can be determined about the HSRP relationship from the displayed debug output？（）
A.Router 172.16.11.111 will be the active router because its HSRP priority is preferred over router172.16.11.112
B.The IP address 172.16.11.112 is the virtual HSRP router IP address
C.The nonpreempt feature is enabled on the 172.16.11.112 router
D.The IP address 172.16.11.111 is the virtual HSRP router IP address
E.Router 172.16.11.112 will be the active router because its HSRP priority is preferred over router172.16.11.111
F.The preempt feature is not enabled on the 172.16.11.111 router
Refer to the exhibit. Based upon the debug output that is shown， which three statements aboutHSRP are true？（）
A.The router with IP address 172.16.11.112 is using default HSRP priority
B.The IP address 172.16.11.115 is the virtual HSRP IP address
C.The priority of the router with IP address 172.16.11.112 is preferred over the router with IPaddress 172.16.11.111
D.The router with IP address 172.16.11.111 haspreempt configured
E.The final active router is the router with IP address 172.16.11.111
F.The router with IP address 172.16.11.112 has nonpreempt configured
Refer to the exhibit. Which two statements are true about the output from the show standby vlan50 command？（）
A.The command standby 1 preempt was added to Catalyst_A
B.Catalyst_A is load sharing traffic in VLAN 50
C.Hosts using the default gateway address of 192.168.1.1 will have their traffic sent to192.168.1.11 even after Catalyst_A becomes available again
D.Hosts using the default gateway address of 192.168.1.2 will have their traffic sent toCatalyst_A
A.Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the router
B.The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address10.10.0.1
C.The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.1
D.DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2
E.The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.6
最新試題
As a network engineer， study the exhibit carefully. Router Net is unable to establish an ADSLconnection with its provider. Which action would correct this problem？（）
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
cisco ios command to interface dialer 0
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Match the xDSL type on the above to the most appropriate implementation on the below.