A. you can apply multiple access lists with the same protocol or in different direction.
B. you can config one access list,per direction,per layer 3 protocol
C. you can place as many access lists as you want on any interface
D. you can apply only one access list on any interface
您可能感興趣的試卷
你可能感興趣的試題
A. spanning-tree mode rapid-pvst
B. spanning-tree uplinkfast
C. spanning-tree backbonefast
D. spanning-tree mode mst
A. they run a spell check on host names to ensure accurate routing
B. they map individual hosts to their specific IP address
C. they convert domain names into IP address
D. Given an IP address,they determine the name of the host that is…
A. Flash,TFTP server,ROM
B. Flash,NVRAM,ROM
C. ROM,NVRAM,TFTP server
D. NVRAM,TFTP server,ROM
E. TFTP server,Flash,NVRAM
A. show session
B. show cdp neighbors
C. show users
D. show queue
A. transport type all
B. transport output all
C. transport preferred all
D. transport input all
最新試題
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
At which layer of the OSI model dose PPP perform?（）
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?（）
Which statement describes the rule of split horizon?（）
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）