A. global unicast
B. anycast
C. multicast
D. unspecified address
您可能感興趣的試卷
你可能感興趣的試題
A. crossover
B. straight-through
C. rolled
D. shielded twisted-pair
A. BackboneFast
B. UplinkFast
C. Root Guard
D. BPDU Guard
E. BPDU Filter
A. 24
B. 4
C. 8
D. 16
A. switch to switch
B. switch to hub
C. switch to router
D. hub to hub
E. router to PC
A. Executing password recovery is required.
B. The virtual terminal lines are misconfigured.
C. Use Telnet to connect to RouterA and then to NewSwitch to correct the error.
D. Power cycle of NewSwitch will return it to a default configuration.
最新試題
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()
Which pairing reflects a correct protocol-and-metric relationship?()
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?()
On which options are standard access list based?()
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()