A. 24
B. 4
C. 8
D. 16
您可能感興趣的試卷
你可能感興趣的試題
A. switch to switch
B. switch to hub
C. switch to router
D. hub to hub
E. router to PC
A. Executing password recovery is required.
B. The virtual terminal lines are misconfigured.
C. Use Telnet to connect to RouterA and then to NewSwitch to correct the error.
D. Power cycle of NewSwitch will return it to a default configuration.
A. Drop the data.
B. Send the data frames to the default gateway.
C. Create an ARP request to get a MAC address for the receiving host.
D. Send a TCP SYN and wait for the SYN ACK with the IP address of the receiving host.
A. RARP request
B. Show Network Address request
C. Proxy ARP request
D. ARP request
E. Show Hardware Address request
A. FTP
B. TFTP
C. TCP
D. UDP
E. SCP
最新試題
At which layer of the OSI model dose PPP perform?()
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
Which statement describes the rule of split horizon?()
On which options are standard access list based?()
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
What is the purpose of the cisco Vlan Trunking protocol?()