A. show ip route
B. show route
C. traceroute
D. trace ip route
您可能感興趣的試卷
你可能感興趣的試題
A. enable cdp
B. cdp enable
C. cdp run
D. run cdp
A. ip route 172.16.1.0 255.255.255.0 0.0.0.0
B. ip route 172.16.1.0 255.255.255.0 172.16.2.1
C. ip route 0.0.0.0 255.255.255.0 172.16.2.1
D. ip route 0.0.0.0 0.0.0.0 172.16.2.1
A. NVRAM
B. RAM
C. FLASH
D. ROM
E. PCMCIA
A. copy running-config: TFTP:
B. copy TFTP: running-config
C. copy TFTP: startup-config
D. copy startup-config: TFTP:
A. copy running-config startup-config
B. copy startup-config: running-config
C. copy running config startup config
D. copy startup config running config
E. write terminal
最新試題
Which pairing reflects a correct protocol-and-metric relationship?()
Which command encrypts all plaintext passwords?()
How are VTP advertisements delivered to switches across the network?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
Three access ports have been installed and configured to a small office.What term defines the wireless topology?()
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()