A.WPA is based on the outdated IEEE 802.11i standard.
B.WPA uses RSN，which uses the same base encryption algorithm as RC4.
C.WPA requires a hardware upgrade that may not be supported by all vendors.
D.WPA uses TKIP，which uses the same base encryption algorithm as WEP.
E.WPA is susceptible to a DoS attack when it receives two packets in quick succession with bad MICs，forcing the AP to shut down the entire Basic Service Set （BSS） for one minute.
F.WPA is susceptible to a security weakness when preshared keys are used.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. What variation of the 802.1x Extensible Authentication Protocol (EAP) uses this authentication process?（）
A.LEAP
B.EAP-FAST
C.PEAP
D.EAP-TLS
A.End-to-end delay is the sum of propagation delays，processing delays，serialization delays，and queuing delays.
B.Coast-to-coast end-to-end delay over an optical link is about 20 ms.
C.Processing delay depends on various factors，which include CPU speed，CPU utilization，IP switching mode， and router architecture.
D.Propagation and serialization delays are related to the media.
E.Propagation delay is the time it takes to transmit a packet and is measured in bits-per-second （bps）.
F.Serialization delay is the time it takes for a router to take the packet from an input interface and put it into the output queue of the output interface.
A.class-based weighted fair queuing （CBWFQ）
B.low latency queuing （LLQ）
C.priority queuing （PQ） or custom queuing （CQ）
D.Real-Time Transport Protocol （RTP） header compression
E.TCP header compression
F.UDP header compression
Refer to the exhibit. Both routers have been configured as VoIP gateways. They must also support traditional telephony devices to connect to analog telephones. Which two configuration changes would correctly support the voice requirements?（）
A.On each router， under the dial-peer voice 1 pots configuration， add the port fa0/0 command.
B.On each router， under the dial-peer voice 1 pots configuration， add the port 1/0/0 command.
C.On each router， configure dial-peer voice 1 as a voip connection and configure dial-peer voice 2 as a pots connection.
D.Under the dial-peer voice 1 pots configuration， change the destination pattern of 1111 to 2222 on the R1 router， and 2222 to 1111 on the R2 router.
E.Under the dial-peer voice 2 voip configuration， change the destination pattern of 1111 to 2222 on the R1 router， and 2222 to 1111 on the R2 router.
F.Under the dial-peer voice 2 voip configuration， change the destination target address of 10.2.2.2 to 10.1.1.1 on the R1 router， and the destination target address of 10.1.1.1 to 10.2.2.2 on the R2 router.
A.automated alternate routing （AAR）
B.Cisco CallManager Attendant Console
C.real-time protocol （RTP）
D.Survivable Remote Site Telephony （SRST）
最新試題
Within the WMM policy， how many default QoS radio access categories are there？（）
Which two QoS classification and marking statements are true？ （）
Which three benefits are realized by implementing Wireless LAN Solution Engine （WLSE）？（）
In a VoIP network， which type of interface would an analog fax machine connect to？（）
Which three user interfaces exist for the Cisco WLAN Controllers？（）
What are three factors used to determine the amount of bandwidth that is required for a single VoIP call？ （）
Which set of classes correctly identifies the four traffic classes， from highest priority to lowest priority， specified in the 802.11e standard？（）
Which three functions can an Integrated Services Router perform in a VoIP network？（）
Which two commands should be entered on a WLAN controller to remove any residual configuration？（）
In the design of a QoS solution， which two factors should be taken into consideration？（）