A.Implementing DiffServ involves the configuration of RSVP.
B.Implementing IntServ allows QoS to be performed by configuring only the ingress and egress devices.
C.Implementing IntServ involves the utilization of RSVP.
D.Traffic should be classified and marked by the core network devices.
E.Traffic should be classified and marked as close to the edge of the network as possible.
您可能感興趣的試卷
你可能感興趣的試題
A.CAC provides guaranteed voice quality on a link.
B.CAC artificially limits the number of concurrent voice calls.
C.CAC is used to control the amount of bandwidth that is taken by a call on a link.
D.CAC prevents oversubscription of WAN resources that is caused by too much voice traffic.
E.CAC allows an unlimited number of voice calls while severely restricting，if necessary，other forms of traffic.
F.CAC solves voice congestion problems by using QoS to give priority to UDP traffic.
A.To support fault and policy reporting，the WLSE requires a Wireless Control System （WCS）.
B.When WLSE detects an AP failure，it automatically increases the power and cell coverage of nearbyAPs.
C.WLSE requires the 2700 location appliance to offer location tracking.
D.WLSE can locate rogue APs and automatically shut them down.
E.WLSE configuration is done using the command line interface （CLI） or a WEB based template.
A.A TACACS+ server is required to implement 802.1x.
B.MIC protects against man-in-the-middle and replay attacks.
C.The 802.1x standard provides encryption services for wireless clients.
D.The AES （symmetric block cipher） is specified in the IEEE 802.11i specification.
E.The IEEE 802.11i specification uses RC4 as its encryption mechanism.
F.WPA requires TKIP and AES as encryption methods.
A.AutoQoS is supported on Frame Relay multipoint subinterfaces.
B.AutoQoS is supported on low-speed ATM PVCs in point-to-point subinterfaces.
C.AutoQoS is supported on serial PPP and HDLC interfaces.
D.AutoQoS is supported only on Frame Relay main interfaces and not on any subinterface configuration.
A.Business-critical traffic includes VoIP and voice signaling packets.
B.SDM can be used to configure a basic QoS policy for incoming traffic on WAN interfaces and IPsec tunnels.
C.SDM can provide QoS for real-time traffic and business-critical traffic.
D.SDM creates a custom-queuing （CQ） or a priority-queuing （PQ） policy.
E.SDM creates a low latency queuing （LLQ） service policy with its associated classes.
F.When allocating bandwidth， values can be entered in either bandwidth percentage or kilobytes per second （kBps）.
最新試題
What are two reasons to implement H·323 gatekeepers？（）
What are three factors used to determine the amount of bandwidth that is required for a single VoIP call？ （）
Which two commands should be entered on a WLAN controller to remove any residual configuration？（）
What can be used to maintain the voice quality on a link by limiting the number of calls that can be active at any given time？（）
Which two VoIP capabilities are utilized when the CallManager and the gateway are configured for Survivable Remote Site Telephony？（）
When QoS levels in the Cisco Wireless Control System （WCS） are entered， which profile names are used to identify the access categories？（）
When Cisco SDM is used to generate QoS policy， various QoS classes will be created and assigned a percentage of the interface bandwidth. Which three statements indicate the default bandwidth values that are assigned by SDM for outgoing traffic on a WAN interface？ （）
What are two ways to minimize the delay of VoIP packets that are traversing a network？ （）
End-to-end QoS is maintained in the Cisco WLAN deployment model by utilizing what parameter in lieu of 802.1p？（）
What is the term that is used to describe the process of converting a signal from digital to analog？（）