Routers R1， R2， and R3 are configured in a hub and spoke frame relay environment， with router R1 as the hub. You have configured Router R1， Router R2， and Router R3 to run EIGRP over the frame relay connections. No sub-interfaces are used. You have configured a single IP subnet on all the Frame Relay interfaces. Router R1 can reach both router R2 and R3， but R2 and R3 can not reach each other. What is the probable cause of this problem？
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Routers A and B are directly connected and running EIGRP，but they are unable to form a neighbor relationship. What is the most likely cause？（）
A.The network statements are misconfigured.
B.The IP address statements are misconfigured.
C.The autonomous system is misconfigured.
D.There is a physical issue with the cable.
Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards， the exhibit shows your configuration in a local switch1. However， EtherChannel is not coming up. Which one of these statements could be a possible reason？（）
A.EtherChannel is only available in Cisco equipment.
B.The customer side is supposed to be running PAgP， which is a Cisco standard.
C.PAgP is not an IEEE standard. VRRP should be used.
D.The configuration on switch1 needs to be modified to use LACP
Refer to the exhibit. Routers A and B are directly connected. Given the configuration, how many EIGRP routes will router B see in its routing table?（）
A.0
B.1
C.2
D.3
E.4
最新試題
什么是NAT？
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown？（）
A default Frame Relay WAN is classified as what type of physical network?（）
What is method list for configure aaa？
what is the advantage of policing opposite to shaping？
aaa架構中哪個是要求用戶輸入用戶名和密碼？
what is four ospf area type？
QoS機制中的分類，采用ip數據包中的哪個字段？
What is the three main step of using the QoS feature with MQC command line interface？
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）