A.2001：DB8：：1 and 2001：DB8：：2
B.2001：DB8：：9 and 2001：DB8：：10
C.2001：DB8：：10 and 2001：DB8：：17
D.2001：DB8：：1 and 2001：DB8：：18
您可能感興趣的試卷
你可能感興趣的試題
A.The autoconfig command is missing from the router interface.
B.IPv6 multicast routing is not enabled on the router interface.
C.IPv6 unicast routing is not enabled on the router interface.
D.The router interface is configured with a /63 mask.
E.The router interface is configured with a /65 mask.
A. anycast address
B. site-local multicast
C. global address of the link
D. unique local address
E. link-local address
A.On-Passive
B.On-Auto
C.Passive-Active
D.Desirable-Auto
E.Active-Active
F.Desirable-Desirable
A. IPv6 prefixes
B. link-local addresses
C. solicited node multicast addresses
D. IPv6 prefixes and topology information
A. An IPv4-compatible tunnel is a static tunnel， but an 6to4 tunnel is a semiautomatic tunnel.
B. The deployment of a IPv4-compatible tunnel requires a special code on the edge routers， but a 6to4 tunnel does not require any special code.
C. An IPv4-compatible tunnel is typically used only between two IPv6 domains， but a 6to4 tunnel is used to connect to connect two or more IPv6 domains.
D. For an IPv4-compatible tunnel， the ISP assigns only IPv4 addresses for each domain， but for a 6to4 tunnel， the ISP assigns only IPv6 addresses for each domain.
最新試題
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）
Which of the following is true about the MPLS header and its EXP field size？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
In GLBP，which router will answer on client ARP requests？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
What is the correct command to set the router ID for an OSPFv3 process？（）
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain？（）
Which three options are valid ways to filter routes from a BGP peer？（）